Infusion
Notox surfboards combine upcycled carbon fiber from Airbus with Sicomin bio-resin
One-hundred percent upcycled fabrics declared unusable for aerospace applications go through a wet lamination process with vacuum bag consolidation to produce the sustainable Notox R-Carbon products.
Read More
Brazilian-founded Blue Wind supplies more than 900 composite nacelles to U.S. wind energy market
The Florida-based manufacturer began its nacelle exporting operations during the pandemic. Now, supporting GE Renewable Energy, Blue Wind strives to surpass the mark of 500 nacelles in 2022.
Read More
Sensors: Data for next-gen composites manufacturing
In the quest for sustainability, sensors are reducing cycle times, energy use and waste, automating closed-loop process control and increasing knowledge to open new possibilities for intelligent manufacturing and structures.
Watch
Resin-infused center console boat configuration proves higher performance, speed, quality
Hayaari Marine employs a revised infusion setup using semi-permeable membranes to eliminate porosity and improve laminate consolidation, reducing about 450 kilograms of resin per boat, and offering 20% weight savings.
Read More
Air-cushion barge serves ice, shallow water operations with infused carbon fiber propellor ducts
Four composite propellor ducts supplied by A C Marine & Composite drive forward the steel-built hybrid hovercraft design to provide essential services year-round in the North Caspian Sea.
Read More
Fingerprinting liquids for composites
Collo uses electromagnetic sensors and edge analytics to optimize resin degassing, mixing, infusion, polymerization and cure as well as monitoring drift from benchmarked process parameters and enabling in-situ process control.
Watch
DNV lowers the partial reduction factor γm1 of wind turbine blades using aging-resistant PU
The adjustment certification, which gives lower safety margins to polyurethane (PU) resin used in rotor blades, marks broader blade design and applications for Covestro.
Read More
MS-21-300 debuts first flight with carbon fiber wing
Certification of the MS-21-300 aircraft is nearing completion, with plans to start delivering it to customers in 2022.
Read More
NCC sensor technology unlocks digital potential for liquid resin processes
Research and testing of dielectric sensors performed by the NCC, Meggitt and Cranfield University accurately captures resin infusion data, shows promise for composites manufacturing.
Read More
Top 10 ÂÌñÏ×ÆÞ articles of 2021
As this year comes to a close, ÂÌñÏ×ÆÞ is taking some time to reflect on what the year held for those in the composites industry. Take a look at the most popular articles of 2021.
Read More