Processes
Caracol obtains AS/EN 9100 certification for large-scale, robotic-mounted 3D printer
Italy-based large-scale AM specialist secures accreditation to produce aerospace parts. The company is currently scaling up production of various aircraft, launcher and satellite components.
Read More
Continuous Composite Systems (CCS) – enhanced strength and rigidity
With our Continuous Composite Systems (CCS) products and process, L&L Products can deliver a cost-effective, lightweight, ultra-high strength reinforcement solution that brings extensive engineering knowledge, advanced CAE modeling, and the ability for adhesive use in a variety of applications. (Sponsored)
Watch
DNV lowers the partial reduction factor γm1 of wind turbine blades using aging-resistant PU
The adjustment certification, which gives lower safety margins to polyurethane (PU) resin used in rotor blades, marks broader blade design and applications for Covestro.
Read More
Suprem thermoplastic composites contribute to pressure vessel expansion
High-quality, high-performance UD thermoplastics are dedicated to industrializing recyclable Type III, IV and V pressure vessels.
Read More
Arris Composites announces Sustainable Consumer Products Program using Additive Molding technology
Oval bezel demonstrator for consumer electronics has sub-millimeter features, out-performs metal, is antenna transparent and more than 50% of the matrix comes from a renewable plant source.
Watch
Quiet supersonic demonstrator X-59 begins ground testing in Texas
Critical testing ensure the composite aircraft can withstand the loads and stresses that typically occur during supersonic flight.
Read More
MS-21-300 debuts first flight with carbon fiber wing
Certification of the MS-21-300 aircraft is nearing completion, with plans to start delivering it to customers in 2022.
Read More
Thermwood receives 32 granted additive manufacturing patents
New patents add to the company’s broad selection of already-patented LSAM equipment.
Read More
Auburn University make strides in advancing bio-based polymers and fibers for 3D-printed home construction
Interdisciplinary project utilizes biomaterial waste for sustainable composites development to produce resilient buildings with a low carbon footprint.
Read More
NCC sensor technology unlocks digital potential for liquid resin processes
Research and testing of dielectric sensors performed by the NCC, Meggitt and Cranfield University accurately captures resin infusion data, shows promise for composites manufacturing.
Read More