ÂÌñÏ×ÆÞ

Photo Credit: Telene SAS

(Bondues, France), in partnership with bus and coach company, Ebusco (Deurne, Netherlands), have developed two composite parts for the Ebusco 3.0 electric city bus. The first part supports the large rear window, while the second part is mounted on brackets, enabling access to the electrical system.

Ebusco reportedly recognized early on the necessity of a lightweight bus structure and, in close collaboration with Pondus Operations (Deurne, Netherlands), developed the composite body-in-white (BIW) for the Ebusco 3.0. The material of choice was Telene’s poly dicyclopentadiene (PDCPD), which offered various advantages for the development of lightweight and durable body panels. Further, the material would enable a lower total cost of ownership (TCO).

Featured Content

Assembling the Multifunctional Fuselage Demonstrator: The final welds READ MORE

Composites end markets: Sports and recreation (2025) READ MORE

Automated Composites Knowledge Center READ MORE

Additionally, Telene’s low-viscosity resin systems (10 millipascal-seconds) are said to achieve similar injection and cycle times as high-pressure resin transfer molding (HP-RTM), but at low injection pressures. Benefits include significant threshold reduction, making fast-RTM technology accessible for electrical buses or vehicles produced in smaller series than typical automotive applications.

Ebusco 3.0 parts are roughly two meters wide and 55 and 35 centimeters wide respectively, at a thickness of three millimeters. Injection time for the parts were less than 40 seconds at 60°C, (three kilograms of resin) with pressure under 10 bars. Cycle time was less than five minutes. Note this was achieved for the initial parts without any further optimization. Post cure was performed at 130°C.

According to Ebusco, the parts show superior damage tolerance, for longer part life and reduced repair or replacement costs. Additional advantages include lower weight and elimination of release agent needs. When compared to epoxy and polyurethane, Telene’s low-density matrix resulted in lower part weight.

“The Telene team has exceeded our expectations in delivering the first Telene composite parts for Ebusco 3.0,” says Edwin van Herpt, director R&T – Composites at Pondus Operations. “We are discussing additional parts thanks to the multiple advantages Telene composites offer.”

This post is courtesy of the ÂÌñÏ×ÆÞ and  media partnership.